Tag Archives: electronics

Bench Power Supply Build – Part II

This is the second post on my power supply build – also see part I and the Circuitmaker project page.  The aim of this project is to design and build a linear bench power supply with adjustable current and voltage and up to 2.5A output from 0-30V.

After building and testing the first version of the board I discovered a couple of issues. Most of the basic functionality worked – the voltage control, digital display, transformer tap select, etc. However, the current limiting never worked properly, there were some noise/oscillation issues and a couple of mechanical problems. So, Rev.1.1 was born which has now been tested and seems to be working nicely.

Continue reading Bench Power Supply Build – Part II

Advertisements

Temperature Logger

I have finally finished my temperature monitor and logging module, originally designed to monitor beer temperature as it is fermenting (beer, fridge and ambient temperatures). It is an Arduino-based device which measures and displays temperatures from multiple attached temperature probes and logs them to an SD card . This is an old project from last year sometime which has been sitting 95% complete, just waiting on an enclosure and some finishing touches to the code. I posted a separate post about the enclosure design and 3D print, read it here.

Continue reading Temperature Logger

Servo Motor Control with Mojo FPGA board

This post is part of my series on building a kinetic sculpture with the Mojo  FPGA development board. (Part1 Part2)

My Mojo development board finally turned up and so I’ve been playing around with it for the last week. This post  is just a quick update of some fist test code to control some servo motors and sweep them back and forth. The end goal of this project is full independent control of multiple servos to create moving sculptures. See this post for an overview of the project.

Continue reading Servo Motor Control with Mojo FPGA board

Bench power supply build – part I

This is the first post on my power supply build. Also see part II and the Circuitmaker project page.

An adjustable bench power supply has been on my list of things to build for quite a while. A linear supply should be relatively simple to design, with the added bonus of being a useful thing to have around. My goals with this project are to design and build a slightly more complex system than I have in the past, to lean to use PCB layout software and to actually get a PCB designed and manufactured. I wanted to design it from scratch, rather than using an adjustable 3 terminal regulator or a controller chip with everything built in – this is supposed to be a learning experience more than anything else.

My requirements are:

  • 0-30V adjustable voltage
  • 0-2A with current limiting.
  • Separate fixed 5V output for powering digital circuits.

Continue reading Bench power supply build – part I