This is the second post on my power supply build – also see part I and the Circuitmaker project page. The aim of this project is to design and build a linear bench power supply with adjustable current and voltage and up to 2.5A output from 0-30V.
After building and testing the first version of the board I discovered a couple of issues. Most of the basic functionality worked – the voltage control, digital display, transformer tap select, etc. However, the current limiting never worked properly, there were some noise/oscillation issues and a couple of mechanical problems. So, Rev.1.1 was born which has now been tested and seems to be working nicely.
Continue reading Bench Power Supply Build – Part II
This is the first post on my power supply build. Also see part II and the Circuitmaker project page.
An adjustable bench power supply has been on my list of things to build for quite a while. A linear supply should be relatively simple to design, with the added bonus of being a useful thing to have around. My goals with this project are to design and build a slightly more complex system than I have in the past, to lean to use PCB layout software and to actually get a PCB designed and manufactured. I wanted to design it from scratch, rather than using an adjustable 3 terminal regulator or a controller chip with everything built in – this is supposed to be a learning experience more than anything else.
My requirements are:
- 0-30V adjustable voltage
- 0-2A with current limiting.
- Separate fixed 5V output for powering digital circuits.
Continue reading Bench power supply build – part I