matt – Danger From Deer

July 23, 2021 matt

Building a wooden cabinet

This cabinet was designed for the living room to hold our modem/router and NAS on the lower shelf, covered by a door and with a

November 17, 2020 matt

Setting up an STM32F4 as an SPI device with FreeRTOS and STM32MXCube

In this post I’ll go over my steps to get an STM32F4xx microcontroller running FreeRTOS as an SPI peripheral/device/slave using DMA so it can run

June 3, 2020 matt

More fences! And a new arrival.

We finished off the final section of the “long flat” paddock fence, which means we’ve now got a fully finished large paddock where we can

May 22, 2020 matt

Gate installation details

This time we have a close-up of installing a gate. This one is halfway along one of the sides of the long-flat paddock from the

May 21, 2020 matt

Installing some gates on the “long flat”

Today’s timelapse shows us installing a couple of gates at the entrance to the “long flat” paddock. The previous gate posts were all wooden and

May 17, 2020 matt

Stockyard cleanup – timelapse

The old upper stockyard near the house was all wood and was damaged in the fires. This is the stockyard which is used to move

May 9, 2020 matt

We’re farmers now?

The latest project is helping out on the farm, repairing and rebuilding after the fires at the start of the year. First job, building fences!

April 6, 2016 matt

Bench Power Supply Build – Part II

This is the second post on my power supply build – also see part I and the Circuitmaker project page. The aim of this project is to

March 26, 2016 matt

Temperature Logger

I have finally finished my temperature monitor and logging module, originally designed to monitor beer temperature as it is fermenting (beer, fridge and ambient temperatures).

March 20, 2016 matt

Designing a 3D printed electronics enclosure

This will be a quick post about the design and 3D printing of a custom enclosure for a temperature logger (see full writeup here) –